Installation guide

4. Installing ClickShare

Image 4-5

3. Secure the mounting brackets to the Base Unit using the four T10 screws.

4. M ount the Base U nit to the ceiling with the four mounting screws.

Tip: This procedure should be performed by two people: one person holding the Base U nit in place, one person tightening

the screws.

4.6 Connecting

CAUTION: M ake sure t he Base Unit is installed p roperly before co nn ecting.

To connect the Base Unit before use

1. Plug the power cable in the mains power connector at the back of the Base Unit

Refer to “1” on the ﬁgure below.

Note: The loc al variant of the power cable is included in the ClickShare box at purchase.

2. C onnect the Base Un it to the display using a disp

lay cable.

Refer to “2” on the ﬁgure below.

Note: A display cable is n ot included in the Click Share box at purchase.

Supported types of displays are:

- Single Link DVI

-DisplayPort

- VGA: use the adapter included in the ClickShare box

- HDMI: use an adapter c able (not included in the box )

3. If you want to change settings on the web interface during installation, insert a network cable in the LAN port.

Refer to “3” on the ﬁgure below.

4. To power on the Base Unit, set the rocker switch to “I”.

Refer to “4” on the ﬁgure below.

R5900004 CLICKSHARE 21/08/2012