Installation guide

4. Installing ClickShare
To install the Base Unit in a 19 inch rack
1. R emove the four T10 torx screws at the bottom of the Base Unit.
Image 4-2
Removal of pre-mounted screws
2. Place the Base Unit on the rac k mount and s ecure it by using the four T10 torx screws.
Refer to “1” on the figure below.
3. Fasten the antennae to the front panel of the rack mount.
Refer to “2” on the figure below.
1
2
3
3
2
1
Image 4-3
4. Tighten the antenna c ables to the back of the Bas e Unit.
Refer to “3” on the figure above.
5. U se the four included screws to mount the rack mount into the rack.
16
R5900004 CLICKSHARE 21/08/2012