Manualshelf

Installation guide

ManualsBrandsBarco ManualsComputer equipmentR5900001
51525354555657585960
6. Web Interface
2. Click on the delete button to delete the wallpaper.
The message Successfully applied changes is displayed on top of the page.
6.7 Display settings
About display settings
The following settings can be configured for the display(s):
• Standby timeout. Time between the last ac tion and moment the system goes into standby.
• Meeting room and network information on the startup screen c an be display ed or can be hidden.
• Hot Plug Display detection can be activated so that a display can be connected or unconnected without switching o ff.
• Display identifier s can be displayed on top of the displayed im ages (only when 2 displays are connected)
• Resolution of the display can be set.
To change
1. Log in t o the ClickShare web interface.
2. Click the Se tup tab (1) and then the Display tab (2).
The content of the Display tab is shown. The first pane s hows the Display Settings.
Image 6-11
Display settings
3. Display Timeout setup. Click on the drop-down list and select the time interval of inactivity after which the display output is
disabled (standby mode).
By default, the d isplay time-out is set to ’Infinite’.
4. To show the meeting room and network info on the meeting room display, check t he check box behind the c orresponding item.
5. To activate the Hot Plug Display Detection, check the check box behind that item.
6. To show the display identifiers, check the check box behind that item.
7. Resolution setup. Click on the drop-down list and select the desired resolution or select Custom and enter a resolution manually.
Note: By de fault, the correct re solution is automatically set through the EDID (Extended Display Identification Data).
Note: The m aximum output resolution supported by ClickShare is 19 20 x 1200. This inc ludes Full HD 192 0 x 1080.
8. Click Apply to confirm your change s.
Note about EDID
The timings of the C lickShare Base U n it display output are based on the inform ation contained in the EDID of the m eeting room
display or projector. Such an EDID contains at least the following information:
42
R5900004 CLICKSHARE 04/12/2013