Installation guide

4. ClickShare installation
4.6 Video signal connections to the Base Unit
CAUTION: M ake sure t he Base Unit is installed p roperly before co nn ecting.
About Video signal connection
Depending on the local setup, a single screen or dual screen s etup is possible.
For a single screen setup, a DVI or DisplayPort connection should be made between the Base Unit and the display.
For a dual screen setup, a DVI and a DisplayPort connection should be m ade between the Base Unit and the displays.
To connect
1. Connect the Base Unit to the display(s) using display cables.
Refer to “1” on image 4-6.
1
Image 4-6
Display cables connection
Note: Display cables are not included in the ClickShare box at purchase.
Supported types of displays are:
- Single Link D V I
-DisplayPort
- VGA: use the adapter inc luded in the ClickShare box (reduced blanking on highest res olution)
- HDMI: use an adap ter cable (not included in the box)
- 2560x1080 via Dual Link DVI: Use Barco kit B5606021.
Whe n setting up a single display configuration, connect the DVI-I or the DisplayPort cable to the display.
When setting up a dual display configuration, connect t he DVI-I connector with display 1 and the DisplayPort connector with
display 2.
R5900004 CLICKSHARE 04/12/2013 23