Installation guide

2. ClickShare Specifications

2 1 3 2

Image 2-3

Base Unit

1 USB port

2 Status LED strip

3 Standby button

Table 2 - 3

USB port

The USB port is used to update the software of both the Base Unit and the Buttons.

When plugging in the Button into the B ase Unit, the Button is paired to the Base U nit. The Base U nit checks whether the Button’s

software and ﬁrmware ar e up to date. If not, the B ase Unit upda tes the software and/or ﬁrmware.

To update the Base Unit software, download the latest v ersion of the software f rom the Barco website. Copy the ﬁle on a USB stick

and plug it into the USB port of the Base U nit. Follow the progress and instructions on the display.

Status LED strips

The c olor of the LEDs at the front of the Base Unit

give information on the status of the sy stem.

LEDs behavior Explanation

static re d

• receiving content from the Buttons and streaming towards the display.

• pairing and software update of the Button is done. You can now unplug the

Button from the Base Unit.

• during the ﬁrst phase of the Base Unit boot process.

blinking white

• system is s tarting up ( during the second phase)

• Button pairing is in progress

• software update of the Base Unit

slow blinking white

• standby mode (i.e. muting the display output)

static white

• awake and ready (i.e. showing the wel

come m e ssage on the display)

• pairing is done

red blinking

• an error occ u rre d

Standby button

The b utton at the front of the B ase Unit h as a power on/off function and a standby function.

• When the system is awake, a short push triggers the system to go into standby mode.

• When the sy stem is in standby mode, a short push triggers the system to w ake up.

• When the system is powere d on, a long push mak es the system to s hut down and power off.

• When the system is shut dow n, a long push or short push triggers the system to start up.

R5900004 CLICKSHARE 04/12/2013