Projector User Manual
Table Of Contents
- toc
- 1. Packaging and Dimensions
- 2. Installation Guidelines
- 3. Connections
- 4. Getting started
- 5. Source Selection
- 6. General Menu
- 7. Image Menu
- 8. Tools Menu
- 9. Signal Menu
- 10. Lamp Menu
- 11. Image files menu
- 12. Display setup
- 13. Installation menu
- 14. Desktop integration
- 15. iQ Network
- 16. General guidelines on Network Configuration
- 17. Exchange
- 18. SNMP services
- 19. Troubleshooting
- 20. Cleaning the dustfilters
- 21. Standard Image Files
7. Image Menu
0
42
83
125
167
40
80
120
160
FILM
24 f/s
VIDEO PAL
50f/s
NTSC VIDEO
60 f/s
0
1/20s
1/30s
50
83
133
167
2/2
3/2
Image 7-21
film to video conversion: 2/2 and 2/3 pull down method
The filmmode detection insures that these converted signals are shown without artefacts, especially motion artefacts due to bad
de-interlacing.
Image 7-22
This function may cause undesired effects on standard sources, therefore it can be disabled (OFF) at any time
Enabling/disabling the filmmode detection
1. Press MENU to activate the Toolbar
2. Press → to select the Image item
3. Press ↓ to Pull down the Imag e
menu
4. Use ↑ or ↓ to select Filmm ode de tection
5. Press → to pull down the menu
6. Use ↓ or ↑ to enable or disable the Filmmode detection
7. Press ENTER
A white bullet shows the active setting (image 7-23)
66
R5976694 IQ PRO R500 01/02/2007