User`s manual

IF Vision / IF Sound Loops P ULSAR BG
Page 2
•
Cable connections to be made
Cable From To
IF Vision Input cable (n° 44)
Left* IF Vision connector (In) J44 on the mainboard
IF Vision Output cable (n° 43)
Right* IF Vision connector
(Out)
J43 on the mainboard
*Left and right as seen from the front.
SOUND IF LOOP
•
Bridges to be set on the mainboard
Bridge Function Position
BR7
Enables / Disables IF Sound Loop remove
•
Cable connections to be made
Cable From To
IF Sound Input cable (n° 40)
Left* IF Sound connector (In) J40 on the mainboard
IF Sound Output cable (n° 38)
Right* IF Sound connector (Out) J38 on the mainboard
*Left and right as seen from the front.
•
Tighten all cables in place with the delivered cable ties.
If the loops are not used, it is needed to connect the external IF links with the cables delivered in the
kit.
3.3 Closing The PULSAR
•
Put the bottom cover back onto the chassis.
•
Tighten the nine screws (Torx 10) while pressing the bottom cover down.
•
Turn the P
ULSAR upright.
•
Put the top cover onto the chassis.
•
Tighten the nine screws (Torx 10) while pressing the top cover down.
•
Replug the power cord.