User`s manual

Video Loop Through P ULSAR BG
Page 2
•
Cable connections to be made.
Cable From To
Video loop through Cable
Right* Main Video connector J52 on the mainboard
* Right as seen from the front.
In case the option Main scrambled / Aux unscrambled is installed:
•
Bridges to be changed on the DC coupled board (see option description Main scrambled / Aux
unscrambled for the location).
Bridge Function Position*
BR1
Main Video input High impedance / 75 Ohm** non-default
*The default position is the marked position.
**When needed the Main Video input can be terminated externally with a terminator of 75 Ohm.
•
Cable connections to be made.
Cable From To
Video loop through Cable
Right* Main Video connector J61 on the mainboard
* Right as seen from the front.
If the loop through is not used it should be terminated with a 75 Ohm termina-
tor.
2.3 Closing The PULSAR
•
Put the bottom cover back onto the chassis.
•
Tighten the nine screws (Torx 10) while pressing the bottom cover down.
•
Turn the P
ULSAR upright.
•
Put the top cover onto the chassis.
•
Tighten the nine screws (Torx 10) while pressing the top cover down.
•
Replug the power cord.
REMARK