User manual
Table Of Contents
- 1. SAFETY
- 2. GENERAL
- 3. PHYSICAL INSTALLATION
- 4. PROJECTOR PARTS AND FUNCTIONS
- 5. GETTING STARTED
- 5.1 RCU & Local keypad
- 5.2 Remote Control and OSD Lite on Screen
- 5.3 Power on projector
- 5.4 Switching to standby
- 5.5 Power off projector
- 5.6 Range of effective remote control signal reception
- 5.7 Source selection
- 5.8 Changing OSD language
- 5.9 Adjusting the lens by horizontal and vertical lens shift
- 5.10 Introduction the OSD Lite on screen
- 6. ADVANCED OSD MENU
- 7. INPUT
- 8. IMAGE
- 9. LAYOUT
- 10. LAMP
- 11. ALIGNMENT
- 12. CONTROL
- 13. SERVICE
- 14. MAINTENANCE
- 15. PROJECTOR SPECIFICATION
- 16. ENVIRONMENTAL INFORMATION
11. ALIGNMENT 54
11.1 Alignment menu overview 54
11.2 Adjusting screen orientation 55
11.3 Rear Projection 55
11.4 Ceiling Mode 56
11.5 Lens Control 56
11.6 Keystone 56
11.7 Dynamic Contrast 56
11.8 Gamma 57
11.9 Internal Patterns 57
11.10
Color Space 57
11.11 Lens To Midposition 57
12. CONTROL 58
12.1 Control menu overview 58
12.2 Eco Network Power 59
12.3 Network 59
12.4 Menu Position 60
12.5 Start Up Logo 61
12.6 Start Up Chime 61
12.7 Trigger1 ~2 61
12.8 Auto Source 61
12.9 Language 61
13. SERVICE 62
13.1 Service menu overview 62
13.2 Service message of the projector 63
13.3 Lamp Hour Reset 63
13.4 Blue Only 63
13.5 Factory Reset 63
TABLE OF CONTENTS