User manual
Table Of Contents
- 1. SAFETY
- 2. GENERAL
- 3. PHYSICAL INSTALLATION
- 4. PROJECTOR PARTS AND FUNCTIONS
- 5. GETTING STARTED
- 5.1 RCU & Local keypad
- 5.2 Remote Control and OSD Lite on Screen
- 5.3 Power on projector
- 5.4 Switching to standby
- 5.5 Power off projector
- 5.6 Range of effective remote control signal reception
- 5.7 Source selection
- 5.8 Changing OSD language
- 5.9 Adjusting the lens by horizontal and vertical lens shift
- 5.10 Introduction the OSD Lite on screen
- 6. ADVANCED OSD MENU
- 7. INPUT
- 8. IMAGE
- 9. LAYOUT
- 10. LAMP
- 11. ALIGNMENT
- 12. CONTROL
- 13. SERVICE
- 14. MAINTENANCE
- 15. PROJECTOR SPECIFICATION
- 16. ENVIRONMENTAL INFORMATION
8. IMAGE 40
8.1 Image menu overview 40
8.2 Contrast 41
8.3 Brightness 41
8.4 Sharpness 42
8.5 Noise Reduction 42
8.6 Color Temperature 42
8.7 Input Balance 43
8.8 Aspect Ratio 45
8.9 Timings 46
8.10 Auto Image 47
9. LAYOUT 48
9.1 Layout menu overview 48
9.2 Zoom 49
9.3 Main Select 49
9.4 PIP Select 50
9.5 PIP Position 50
9.6 PIP 50
10. LAMP 51
10.1 Lamp menu overview 51
10.2 Mode 52
10.3 Lamps 52
10.4 High Altitude Mode 53
10.5 Power 53
10.6 Lamp1 Status 53
10.7 Lamp2 Status 53
10.8 Lamp1 Run Time 53
10.9 Lamp2 Run Time 53
10.10 Lamp Performance 53
TABLE OF CONTENTS