User manual
Table Of Contents
- 1. SAFETY
- 2. GENERAL
- 3. PHYSICAL INSTALLATION
- 4. PROJECTOR PARTS AND FUNCTIONS
- 5. GETTING STARTED
- 5.1 RCU & Local keypad
- 5.2 Remote Control and OSD Lite on Screen
- 5.3 Power on projector
- 5.4 Switching to standby
- 5.5 Power off projector
- 5.6 Range of effective remote control signal reception
- 5.7 Source selection
- 5.8 Changing OSD language
- 5.9 Adjusting the lens by horizontal and vertical lens shift
- 5.10 Introduction the OSD Lite on screen
- 6. ADVANCED OSD MENU
- 7. INPUT
- 8. IMAGE
- 9. LAYOUT
- 10. LAMP
- 11. ALIGNMENT
- 12. CONTROL
- 13. SERVICE
- 14. MAINTENANCE
- 15. PROJECTOR SPECIFICATION
- 16. ENVIRONMENTAL INFORMATION
PJWU-101B 17/10/2014
51
10.Lamp
10. LAMP
Overview
•
Lamp menu overview
•
Lamps Single and Dual setup
•
High Altitue Mode setup
•
Power saving setup
•
Lamp1 and Lamp2 on or off setup
•
Lamp1 and Lamp2 Run Time display
•
Lamp Performance
10.1 Lamp menu overview
LAMPS
Mode
Eco
Normal
Power
LAMPS
Single
Dual
High Altitude
Mode
On
Off
Power 77.3% - 100%
Lamp1 Status
On
Off
Lamp2 Status
On
Off
Lamp1 Run Time XX HRS
Lamp2 Run Time XX HRS
91.4