User manual
Table Of Contents
- 1. SAFETY
- 2. GENERAL
- 3. PHYSICAL INSTALLATION
- 4. PROJECTOR PARTS AND FUNCTIONS
- 5. GETTING STARTED
- 5.1 RCU & Local keypad
- 5.2 Remote Control and OSD Lite on Screen
- 5.3 Power on projector
- 5.4 Switching to standby
- 5.5 Power off projector
- 5.6 Range of effective remote control signal reception
- 5.7 Source selection
- 5.8 Changing OSD language
- 5.9 Adjusting the lens by horizontal and vertical lens shift
- 5.10 Introduction the OSD Lite on screen
- 6. ADVANCED OSD MENU
- 7. INPUT
- 8. IMAGE
- 9. LAYOUT
- 10. LAMP
- 11. ALIGNMENT
- 12. CONTROL
- 13. SERVICE
- 14. MAINTENANCE
- 15. PROJECTOR SPECIFICATION
- 16. ENVIRONMENTAL INFORMATION
1. SAFETY 1
1.1 General considerations 1
1.2 Important safety instructions 2
2. GENERAL 5
2.1 Installation requirements 5
2.2 Unpacking the projector 6
2.3 Initial inspection 7
2.4 Projector configurations 8
2.5 Projector air inlets and outlets 11
2.6 Installation process overview 11
3. PHYSICAL INSTALLATION 12
3.1 Remote control unit (RCU) 12
3.2 Lenses 14
3.3 Connecting the projector with the power net 17
3.4 Alignment of a table mounted projector 19
3.5 Mounting the Ceiling mount 20
4. PROJECTOR PARTS AND FUNCTIONS 21
4.1 Projector front view 21
4.2 Projector Rear view 21
4.3 Input and Communication 22
4.4 Status lights of LED 24
4.5 Connecting the projector to other devices 25
TABLE OF CONTENTS