User Manual and Operating Guide

3. Commands
Pos
Size
Name Description
Content
0x00
Off (hex)
11
power status
0x03
On (hex)
3.87 set rear projection mode, write
About this comma nd
This command sets the rear pr ojection mode.
Request
Pos
Size
Name Description
Content
0 1 set adj byte value known as "set adj"
0x20
set adj (hex)
1 1 adj rear
0xA2
adj rear (hex)
0x00
Off (hex)
2 1 rear projection mode
status
0x01
On (hex)
3.88 set saturation, write
About this comma nd
This com mand sets the sa turation value of the ac tive source .
Request
Pos Size Name Description Content
0 1 set adj byte value known as "set adj"
0x20
set adj (hex)
1 1 adj saturation
0x03
adj saturation (hex)
2 1 saturation v alue range 0->255 saturation value (hex)
3.89 set sharpness, write
About this comma nd
This command sets the sharpness value of the active sou rce.
Request
Pos
Size
Name Description
Content
0 1 set adj byte value known as "set adj"
0x20
set adj (hex)
1 1 adj sharpness
0x05
adj sharpness ( hex)
2 1 sharpness value range 0->14
(OSD range -7->+7)
sharpness v alue (hex)
3.90 set TCP/IP, write
About this comma nd
This command sets the TCP/IP settings of the projector.
46
R5905746 COMMAND CATALOG 06/01/2014