Projector User Manual

3. Kit installation (detailed)
Image 3-17
input module: fixing front screw s
4. Put the preformatter unit next to its correct position and p lug in th e connectors:
- J100, J101, J102 o n the preformatter: data from connectors J82 3, J824 and J825 on the PMP
- J11on the preformatter: power supply from connector 6 on the power b ox
- J410 on the P MP: commands from connector J410 on the local keypad
- J13 on the PM P: command s from the IR receiver
5. Use one screw to fix the three grounding wires to the preformatter
6. Fix the preformatter unit to the input module using four screws
Image 3-18
Preformatter unit: front screws
7. Install the covers (see concerning chapters):
- eng ine fan cover 1
-topcover
- r e ar cover
3.3 Restoring the backup
Procedure
Restore the bac kup using Projector Support tool. For more details, s ee "Backup and restore data", page 15.
3.4 Upgrade the projecto r to the desired software version
Introduction
Projector upgrade is done through Ether
net. Prior to starting the procedure below, make sure the Ethernet settings in the O SD a re
set to the correct values to ma ke Ethernet communication possible between computer and projector.
R59770498 PMP KIT 28/02/2011
13