Projector User Manual

3. Kit installation (detailed)
Image 3-15
PMP: front fixing screws
6. install the input m odule into the projector (see concerning chapter)
3.2.4 Installing the input module
Necessary tools
Torx screw drive r T10
How to i nstall the input module?
1. Put the c onnector next to its c orrect position and plug in the connectors:
- J15: power supply from connector 6 on the power box
- J19: IC2 to connector J320 on the desktop input
- J23; I2C from connector 13 on the power box
- J14: sync from conn ector J4 on the engine controller
- J22: I2C to connector J5 o n the engine controller
- J11: ethernet wire from the front panel
- J2 and J3 on the LV DS interface (which is mounted on the PMP): data from connector
s J200 and J300 on the desktop input
2. Lower the input m odule until it is in its final position an d fixitusingthreefixin g screws
Image 3-16
Input module: fixing screw chasis
3. Fix the front plate o f the input module using
two screws
12
R59770498 PMP KIT 28/02/2011