Projector User Manual

3. Kit installation (detailed)
3. Lift the preformatter unit a bit and unp lug the following connectors:
- J100, J101, J102 on the preformatter: data from the PMP
- J11 on the preformatter: power s upply from the power box
- J410 on the PMP : c omm ands from the local keypad
- J13 on the PM P: command s from the IR receiver
4. Remove the sc rew fixing the three gr ounding wires
5. Flip over the preformatter unit
Or,
Unplug the other connectors on the preformatter unit and remove the unit
6. Remove both fix ing screws on the front panel of the input mod ule
Image 3-2
Input module: fixing front screws
7. Remove the three screws fixing the input module to the chassis
Image 3-3
Input module: fixing screws chasis
8. Lift the input mod ule a bit and unplug the c onnectors on the PMP :
- J15: po wer supply from the power box
- J19: IC2 to the des ktop input
- J23; I2C from the power box
- J14: sync f rom the engine controller
- J22: I2C to the engine controller
- J11: ethernet wire from the front panel
- J2 an d J3 on the LVDS interface (which is mounted on the PMP): data from the d esktop input
9. Remove the input module
3.2.2 Removing the PMP
Necessary tools
Torx screw drive r T10
8
R59770498 PMP KIT 28/02/2011