User manual
Table Of Contents
- User Manual MFCD 1219 (TS) B4100528-03.pdf
- Contents
- 1. Overview
- 1.1 Introduction
- Multi-scan capabilities
- Touch panel
- 1.2 Package contents
- Power Saving
- 1.3 Controls and connectors
- 2. Installation
- 2.1 Precautions
- 2.2 Wall mounting
- Step 1: Remove the panel from the foot
- Step 2: Fix the mounting plate to the wall
- Step 3: Place the panel on the mounting plate
- 2.3 Connecting the signals
- To connect the video & sync signals:
- To connect the power:
- 2.5 Install the software
- 2.4 Starting up
- 3. On-screen display (OSD) menus
- 3.1 How to use the OSD
- 3.2 Description of the menu items
- Main menu
- Color Menu
- Clock Menu
- Panel
- Cabinet
- Touch panel
- Contents
MFCD 1219 (TS) User's Guide 14
**To unlock the Controls, proceed as follows:
1 Press the Power key to switch off the display
2 With one hand, press and hold the <+> and
the <-> key at the same time.
With the other hand, press the Power key
shortly to switch the display on again.
3 Keep holding the <+> and the <-> key for
about 3 seconds.
4 At last, release the <+> and the <-> key.
Now, by pressing the Menu key, the OSD
menu will appear.
Note:
The bottom line of the OSD shows the input type,
current resolution of the monitor and status of
vertical sync. If it shows user mode, one of the
user modes is selected.
Color Menu
Function Description
Auto Balance To automatically adjust the contrast
level of RGB. This does not support
resolution of Mac 832 x 624 at 75Hz.
R To adjust the level of color Red.
G To adjust the level of color Green.
B To adjust the level of color Blue.
Main Menu To return to Main Menu.
Color Menu
- (Down) + (Up)
Auto Balance
Red
68
Green
65
Blue
70
Main Menu >
A1 1024 x 768 - 60.1 48.4k