User manual

Installing the Nio drivers and software
Nio MKII 49
8. When the Setup complete message appears, select Reboot
System Now and click Finish.
Automated display configuration
Once the drivers, software and documentation have been installed and
your system has been rebooted, the Barco Monitor Plug and Play
Software should automatically detect your Barco displays and attach
them to the desktop with the correct resolution. If the Barco Monitor
Plug and Play Software fails to detect your Barco displays or fails to
attach them to the desktop correctly please refer to the section,
“Setting the resolution of your Nio display” on page 105 in the
Troubleshooting section of this manual.
Reinstalling drivers
You can install new drivers or reinstall existing drivers at any time by
using the Barco Set-up wizard on your B
ARCO NIODisplay System
Installation CD-ROM, see Installing the Nio drivers and software on
page 46 of this manual.
Uninstalling the drivers and software
To uninstall the Barco drivers, or software for your Nio Display Systems,
please use the Windows Add/Remove Programs utility. This utility can
be found in the Windows Control Panel.