User manual

Installing the Nio drivers and software
Nio MKII 47
Put the Nio 3MP/5MP display panel in portrait position before
installing the software.
If you wish to change the panel orientation later, the image
orientation will adapt automatically to the panel orientation after
rebooting the PC.
Note: Both displays connected to a single display controller must
have the same physical orientation and resolution in order to be
attached to the Windows desktop.
Driver and software installation
To install your Nio Windows display controller driver and NioWatch
Software for the first time follow the steps below.
If you are reinstalling the drivers or installing a new driver release over
an existing driver release you may skip steps 2 and 3 below:
1. Boot your system, and log in using an account with administrator
privileges.
2. When the Found New Hardware Wizard comes up, click Cancel.
When the System Settings Change window asks you to restart your
computer, click “No”.
3. Run the Barco Product Installation Wizard.
The Barco Product Installation Wizard should start automatically if
you insert the B
ARCO NIODisplay System Installation CD-ROM into
your CD drive after the operating system has started. If your CD
drive’s auto-run is not enabled or the Barco Product Installation
Wizard does not start automatically, you can run the Barco Product
Installation Wizard manually by following these steps:
a) Click the “Start” button in the task bar.
b) Click “Run”.
c) Click “Browse” and browse to the root directory of the
B
ARCO NIODisplay System Installation CD-ROM and click on
the file, “Setup.exe”, and click “Open”.
d) Click “OK”.