User manual

Installing the Nio drivers and software
46 Nio MKII
Installing the Nio drivers and software
Note: The installation dialog will display in English if your
operating system’s language is not supported.
This process applies to the following versions of Windows:
• Windows 2000 Professional,
• Windows XP Professional,
• Windows Professional x64 Edition,
• Windows Server 2003, and
• Windows Server 2003 x64 Edition.
Preparation
Prior to installing your BarcoMed NIO drivers and software you should do
the following:
1. Install the BarcoMed N
IO display controller(s) in your system.
2. Connect the BarcoMed N
IO display panel(s) to the BarcoMed NIO
display controller(s) and power supply(s).
3. Decide if you want to install the NioWatch Software in addition to
the driver.
4. &Decide if you are going to install the Nio driver with DualView
enabled or disabled.
• When DualView is enabled a dual headed display controller
displays two separate desktops, one for each display.
• When DualView is disabled a dual headed display
controller displays a single virtual desktop that spans
across both displays.
5. Decide which Palette Mode you wish to use with the BarcoMed N
IO
display controller. If you are uncertain, use the default setting as
this setting can be changed later using the BarcoMed Driver Tab of
the Windows Display Properties control panel.
6. Put the Nio 2MP display panel in landscape position before
installing the software.