User manual

Display controller installation
34 Nio MKII
Figure 5: PCI and RAID Controller Slots
Installing the BarcoMed NIO display controller
Install the BarcoMed NIO controller in your computer following these
steps:
1. Turn off the power to your computer and disconnect the power
cord, however make sure that the computer chassis is still
grounded.
2. Remove the chassis cover according to the manufacturer’s
instructions. Be sure to observe safety warnings.
3. If you have decided to use the on-board VGA capabilities of the
BarcoMed N
IO (see Using the VGA capabilities of the
BarcoMed N
IO display controller on page 32), you must now
remove any VGA display controller(s) that are currently installed in
the computer or disable any VGA controllers that are integrated
into your PC’s motherboard.
4. Install the BarcoMed N
IO display controller into a free PCI slot,
either 64-bit or 32-bit (see figure 5, for examples of slots). Be sure
that the display controller is seated firmly in the slot.
5. Secure the card to the chassis with the PC’s I/O panel mounting
screw, and replace the chassis cover.
6. Connect the primary display to the connector marked “VID 1” on
the BarcoMed N
IO display controller using the provided DVI cable