User manual

Troubleshooting
119
the display you detached in step 2 above, by right clicking on the
rectangle that represents it and selecting “Attached”.
Now repeat steps 5-8 above for this display.
If you are using a Quad-Head Configuration repeat all of the
above steps for the two displays on the second display controller.
Tip: After installing DualView and setting the resolutions in a
Quad-Head Configuration you may need to drag the heads into
the proper position in the window on the “Settings” tab, so that
the arrangement in the window on the “Settings” tab matches
the physical arrangement of your configuration.
Figure 58: The Windows Display Properties Control Panel Settings
Tab after the drivers have been installed and the resolution set
with DualView Enabled.
Note: The system shown in figure 58 above is a dual-head, single
BarcoMed Nio display controller, with a 3rd party VGA controller
configuration. Your system may look different.