Specifications

Vesa-mount installation

The panel, standard attached to the tilt & swivel foot, is compatible

with the VESA 100 mm standard. So it can be used with an arm stand

according to the VESA 100 mm standard.

Therefore, the tilt & swivel foot must be removed from the panel.

Important

• Use an arm that is approved by VESA (according to the VESA

100 mm standard).

• Use an arm that can support a weight of at least 13 kg (28.66

lbs).

To attach the display to an arm stand:

1. Put the display face down on a clean and soft surface. Be careful

not to damage the panel screen.

2. Remove the tilt & swivel foot cover.

3. Remove the small screw (A) fixing the small plastic cover on top

of the foot. Next, remove the small cover itself.

Figure 22: Display with tilt & swivel foot cover removed

4. Unscrew the 2 screws fixing the round plastic cover (B).