Specifications

Cable routing
47
Cable routing
Routing the signal cables
• Bind the cables in the connector compartment together with
the cable tie inside the connector compartment.
• Put the connector compartment cover back on the display. Pay
attention that the signal cables are positioned under the bulge
in the cover.
• Push the cables into the clips on the rear of the tilt & swivel
foot.
• Bind the cables together above and under the foot, by means
of the 2 velcro strips attached to the inside of the foot cover
(packed inside the accessory box).
• At last, put the foot cover back in place.
To put the foot cover in place:
Figure 21:
1. The foot cover is packaged separately in the accessory box.
Unpack the foot cover.
(2)