Specifications

Driver and Software Installation
67
installing for this hardware has not passed Windows logo
testing.
Automated display configuration
Once the drivers, software and documentation have been installed
and your system has been rebooted, the Barco Monitor Plug and Play
Software should automatically detect your Barco displays and attach
them to the desktop with the correct resolution. If the Barco Monitor
Plug and Play Software fails to detect your Barco displays or fails to
attach them to the desktop correctly please refer to the section,
Setting the resolution of your Barco Coronis Display in the
Configuring Windows section of this manual.
Reinstalling drivers
You can install new drivers or reinstall existing drivers at any time by
using the Barco Set-up wizard on your B
ARCO CORONIS Display System
Installation CD-ROM, see Installing the B
ARCOMED CORONIS or Nio
drivers and software, on page 64 of this manual.
Uninstalling the drivers and software
To uninstall the Barco drivers, software or documentation for your
Barco Coronis Display Systems, please use the Windows Add/Remove
Programs or Uninstall utility. This can be found in the Windows Control
Panel. For Vista use Programs & Features
Note: If you installed your B
ARCOMED CORONIS or Nio drivers with
DualView enabled, the wizard will warn you that DualView must
be disabled before the drivers can be uninstalled. This is normal,
please follow the prompts from the wizard.