Specifications

Display Controller Installation
31
Note: For 6mp, connect Head 1 to left input, and Head 2 to
right input.
Figure 9:
1. Reconnect any cables you have disconnected and plug in the
computer’s power cord.
2. Turn on the display(s) and then your computer.
Turning on your system
If you have properly installed your graphics card, the Windows
start-up messages will appear once the boot procedure is
finished.
Note: Your Barco display(s) will be running in a basic video
mode at a default refresh rate. Higher resolutions and refresh
rates, such as 1536x2048@60Hz, are not available at this stage
of the installation. Once you have installed the B
ARCO CORONIS
Display System drivers and software, the Barco monitor Plug and
IO-Panel for the BarcoMed Coronis, BarcoMed Nio, and
BarcoMed 5MP2FH family of display controllers
X
Head 1 – DVI-D Connection
Y
Head 2 – DVI-D Connection
WARNING - Turn on your display(s) before you turn on
your computer. Failure to do so could damage your dis-
play(s).