User manual

Troubleshooting
77
Figure 29: The Windows Display Properties Control Panel Settings
Tab after the drivers have been installed and the resolution set
with DualView Enabled.
Note: The system shown in 29 above is a dual-head, single
BarcoMed
Nio Display Controller, with a 3rd party VGA controller
configuration. Your system may look different.
Reinstalling or Updating your BarcoMed Nio Driver
Caution: If you previously uninstalled the driver, do not allow Windows’
Plug and Play software reinstall the driver for you.
To reinstall or update only the BarcoMed
Nio Driver, follow the steps
described in the section “Using the BarcoMed Product Installation
Wizard” with the following changes.
1. Boot your system, and log in using an account with administrator
privileges.
2. Insert your
Nio Software CD into your computer’s CD drive. If the
“BarcoMed Product Installation Wizard” doesn’t start within 3