User manual

Display Controller installation
29
Figure 5
If you decide to use a separate VGA monitor as your boot monitor, you
must disable the BarcoMed
Nio ’s on-board VGA capabilities by moving
the jumper to the bottom two pins.
Caution: To use multiple BarcoMed
Nio controllers in a single host with
VGA enabled, you should enable VGA on only ONE of the BarcoMed
Nio
display controllers and disable VGA on ALL the other BarcoMed
Nio
display controllers.
Examples of PCI slots
Although the BarcoMed
Nio display controller has a 64 bit PCI connector,
it functions as a 32 bit board. It may be installed in either a 32 bit or 64
bit slot with no loss of functionality. Figure 6 on page 30 illustrates the
types of slots so that you can correctly identify which one to use for the
BarcoMed
Nio display controller and which ones not to use.