User manual

Display Controller installation
28
Display Controller installation
Caution: Wear a protective ESD strap during installation or handling of
the display controller. Electrostatic charges can damage the display
controller.
Prior to installing your BarcoMed
Nio display controller(s) in your PC
please take a few minutes to familiarize yourself with both the display
controller(s) and the PCI slots in your computer.
Figure 4: The BarcoMed Nio display controller
Using the VGA capabilities of the BarcoMed Nio display controller
Prior to installing the BarcoMed
Nio controller, decide if you are going to
use its on-board VGA capabilities. If you are, check the setting of the
Jumper at J-1 on the graphics board (see figure 5 on page 29). By
default, VGA should be enabled, on the top two pins.