User guide

6. Conference CloneView

6. CONFERENCE CLONEVIEW

6.1 What is Confere nce Clo neView ?

Overview

This application allows the user to clone outputs from 1 or 2 displays to a third display or projector attached

to the same Display Controller. The cloned image will be scaled to ﬁt the resolution of the target display.

The application supports zooming and panning for ease of viewing.

Supported Display Controllers

MXRT-1450 & MXRT-1451, MXRT-2400, MXRT-2500, MXRT-4500, MXRT-5400, MXRT-5450, MXRT-

5500, MXRT-5550, MXRT-7400 & MXRT-7500.

6.2 Con ﬁguration

How to conﬁgure you r display(s)

1. Start the Conference CloneView application either from the desktop icon or from Start -> Programs

-> Barco, this will display the conﬁguration window.

2. Select the Display Controller that is connected to the display(s) y

ouwouldliketoclonefromthedrop

down list. You can only clone displays connected to the same Display Controller. Click on Identify to

see the displays connected to the currently selected Display Controller.

3. Select up to two source display(s) to clone from, and the target display where the cloned image will

display, and click on the Create Clone button. By default, the source image(s) will be downscaled to

ﬁt the cloned display, while maintaining the original aspect ratio. Select Stretch to ﬁll to stretch the

cloned image to ﬁt the cloned display’s resolution, ignoring aspect ratio.

4. Once all desired cloning has been conﬁgured, you may close the conﬁguration window. The selected

cloning conﬁguration will persist during reboots until the user elects to stop cloning.

5. To stop cloning, click on the Stop Cloning buttonintheconﬁguration window. Alternatively, right click

on the cloned display and select Stop Cloning from the context menu.

K5905271 DISPLAY CONTROLLER 11/09/2014