User guide

4. Driver and software installation
-MXRTdriver(s)
- BarcoMed Self Exam: Barco diagnostic tool
- QAWebAgent: Barco calibration software2
- SingleView: This application is required to configure Barco Fusion displays into SingleView mode
or back into DualView mode. In SingleView, the display has a single landscape resolution, and in
DualView, it has two side-by-side portrait resolutions.
- Conference CloneView: An application that allows the user to clone 1 or 2 displays to a third display,
such as a projector.
- Driver Cleaner: An application that will remove all Barco software components from your workstation.
- Display Installer: This file allows Windows to recognize Barco displays.
-MicrosoftHotfix for KB2496400: Resolved the issue that monitor configuration is lost after you restart
a computer that is running Windows 7.
In a configuration that includes an MXRT-1150/2150 and other MXRT boards, two separate drivers
will be installed. The master installation program will make two passes through the driver installation
process (i.e. License Agreement, Verify Installation Options, etc.).
4. If a previous installation of an MXRT driver exists, the installation wizard will detect it and guide you
through the uninstallation process if necessary.
5. Click Yes to accept the driver’s License Agreement, and then Next to continue.
6. You will be prompted for Express o r Custom Installation. By default, the Express Install option is se-
lected. Custom Installation prompts two installation options:
- 30-bit Desktop: This option allows high dynamic range visualization of medical imaging on grayscale
and color displays.
- SingleView: This option sets all Barco Fusion displays into SingleView mode.
7. During installation, the desktop may flash, and the Installation Wizard window may appear on different
displays. This is expected behavior.
8. When the installation of all components has completed, the automatic reboot window will b
e displayed.
Allow the system to reboot.
4.3 After installation
Installation verification
To verify that the driver was installed, go to the Windows Control Panel,selectSystem, select Device
Manager, then select Display Adapters. Verify that Barco Display Controllers are properly identified, as
shown below:
K5905271 DISPLAY CONTROLLER 11/09/2014
25