User guide

4. Driver and software installation

4. DRIVER AND SOFTWARE

INSTALLATION

4.1 Driver and so ftware in stallation prerequisites

Prerequisites

To install or remove the drivers, software, or documentation you must be logged on as

a user with administrator privileges.

Your operating system must be installed and running before you can install the driver, software and doc-

umentation for the Barco Display Controller(s) for your Barco Display System.

Before you begin, make sure that all of your Barco Displays are connected to the appropriate Display

Controller(s) in your system.

4.2 Installing the Barco M XRT drivers and software

Introduction

This chapter will guide you through the installation of the driver

s, software and documentation associated

with your Barco Display System or Barco Display Controller(s).

The installation dialog wil l display in English if your operating system’s language is not

supported.

This process applies to the following versions of Windows:

• Windows 7 32-bit

• Windows 7 64-bit

• Windows 8.1 32-bit

• Windows 8.1 64-bit

For optimal sys te m perform ance, Barco recommends installing no more than two

drivers on a system at one time. If the conﬁguration will require three drivers, the Barco

Driver Installer will alert the user to replace one board to eliminate one of the drivers.

You will need to install the Barco Display Controller system drivers and software in the following cases:

K5905271 DISPLAY CONTROLLER 11/09/2014