User manual

First installation 46
b) The problem is probably caused by the remote ID’s
Proceed as follows:
1 In the Search error page, select Redefine the remote ID’s.
Click on Next to continue.
2 The Wizard indicates the maximum number of Barco displays you can
add. This is the number of imaging board heads in the computer.
In the field, enter the total number of Barco displays you want to add.
This number should not exceed the number given by the Wizard.
3 The Wizard indicates it will start an interactive procedure to set the
remote addresses correctly.
First, check if the data cables between the computer and all Barco
displays are connected correctly.
When ready, click on Next to continue.