User manual

First installation 45
• Some of the displays have equal remote addresses.
The remote addresses can be set by means of the display’s OSD
menus.
The Wizard provides two ways to solve a search problem, taking the
above-mentioned possible causes into account.
Note:
The search error solving methods can work only for Barco CRT displays
connected through a serial connection. For flat panel or non-Barco
displays these methods are not applicable.
To solve a search error, proceed as follows:
a) The problem is probably caused by the data cables
This is the most common cause and the easiest one to examine.
Therefore, we suggest you consider this option first.
Proceed as follows:
1 Check the hardware connection of data cables. Please refer to the
Installation chapter to find out how the data cables should be
connected.
2 Select Check the cables and search again.
Click on Next to continue.
3 The Wizard displays the Barco Displays page again.
Click on Next to start a new search for Barco displays.
The Wizard now continues with step 3 of the normal, previously described
sequence.
If the connection problem persists, the Wizard will arrive at the search
error page again. If this is the case, the problem may be caused by
overlapping remote addresses (ID’s).