User manual

First installation 37
Yes You can proceed with the Wizard, adding Barco- and / or non-
Barco displays. Continue with step 5.
No The Wizard gives a search error.
Refer to § Solving Configuration Setup Wizard search errors , “
Solving Configuration Setup Wizard search errors “ for more
information about what to do in case of a search error.
Click on Next to continue.
5 Define Heads
Note: This step is skipped if only Barco flat panel displays have been
found.
If the Wizard has found one or more Barco displays, it identifies the first
one by communicating its serial number and by dimming the display’s
screen a few times.
Add the display to the configuration by selecting the imaging board head
it is connected to. This is the character in the white square in the lower
right corner.
If you are not sure which head to select, click on Show this display. As a
result, the display screen will be dimmed again. Select the head of which
the character appears on the dimmed display.
Click on the Next button to add the next display. Repeat this until all Barco
displays are added.
If you add Barco displays only, please continue with step 9.
If you are adding non-Barco displays as well, please continue with the
following step.