Installation manual

8. Final Adjustment and Configuration
OverView D 50" – DOC-3303-5 – installation manual – Revision 11 – November 2006
________________________________
________________________________________________________________
_________________________________________________________
__________________________________________________
_________________________
8-14
Selecting Service | Color/Brightness | Color Coordinate Adjustment displays the following dialog box:
Figure 8-18
dialog box Color Coordinate Adjustment
The dialog box refers to the active lamp!
The data need to be set individually for each lamp!
The Enable/Disable selection always refers to both lamps!
Click on the arrow next to the respective text field to get a list of the available options:
Parameter Possible value
Parameter 1
Measured
Desired
Parameter 2
X coordinate (should be within the measured triangle of the factory colors)
Y coordinate (should be within the measured triangle of the factory colors)
Luminance (if Parameter 1 == Measured), otherwise grayed out
The relative luminance of a color is defined as the ratio of the luminance of this color to the
luminance of white
(which – per definition – equals 1).
Gain (if Parameter 1 == Desired), otherwise grayed out.
Gain should be set to 1 to prevent clipping!
Colour
Red
Green
Blue
Cyan
Yellow
Magenta
White
Value
Value of coordinate in the x, y chromaticity diagram, CIE 1931