Installation manual

8. Final Adjustment and Configuration
OverView D 50" – DOC-3303-5 – installation manual – Revision 11 – November 2006
________________________________
________________________________________________________________
__________________________________________________________
____________________________________________________
__________________________
8-9
8.5.1.2 How to Program an Address into the RCU?
Press the ADDRESS key (recessed key on the RCU) with a pencil and enter the address with the digit buttons
within 5 seconds after pushing the address key. That address can be any digit between 0 and 9.
8.5.2 RS232 baudrate
Figure 8-13
Service Menu, RS232 baud rate
For servicing reasons, higher baud rates can be selected.
Please keep in mind that with firmware 2.x 115200 should only be selected in a single projector
connection.
Standard baud rate which is supported by wall management software is still 9600!
However, projectors with Firmware 3.x might be operated with the OverView Control Manager at
115200.