Installation manual

8. Final Adjustment and Configuration
OverView D 50" – DOC-3303-5 – installation manual – Revision 11 – November 2006
________________________________
________________________________________________________________
__________________________________________________________
____________________________________________________
__________________________
8-7
8.5.1 Projector Address
Projectors leaving production are all set to a projector address "255". When installed in a Display Wall, every
projector has to get a unique address via it can be controlled. This address can be set between 0 and 9 (IR
Remote-Control) or between 0 and 255 (RS232 Remote-Control). CAST as well as the RS232 command
interface and the IR Remote-Control Unit will talk to a specific projector by means of this address.
By means of the common RC5 address the IR Remote-Control can talk simultaneously to all projectors of a
Display Wall.
The common RC5 address can be set either to 0 or to 1.
Please note that CAST (Color Adjustment Service Tools) requires that the projector
addresses are assigned as indicated in the picture below.
It is highly recommended to follow this instruction in case for the future use of CAST!
Figure 8-10
projector addresses as required by CAST,
Display Wall seen from front, A: top row
To modify the projector address:
• Move the cursor to Projector Address.
• Press Enter to select.