Installation manual

8. Final Adjustment and Configuration
OverView D 50" – DOC-3303-5 – installation manual – Revision 11 – November 2006
________________________________
________________________________________________________________
__________________________________________________________
____________________________________________________
__________________________
8-5
Figure 8-6
Lamps menu, Lamp optimization
This procedure optimizes the coupling of the active lamp into the optical system of the
projector and is immediately triggered by selecting the command Lamp Optimization.
During this procedure, the display gets dark for about 30seconds.
• Use the cursor keys to highlight Lamp Optimization
• Press ENTER to select.
If Operation|Message Box is enabled, the following message box is displayed:
Figure 8-7
Lamp optimization in progress
The procedure should be performed subsequently for both lamps.
All other steps to configure the system have to be done in the service menu.