Installation manual

8. Final Adjustment and Configuration
OverView D 50" – DOC-3303-5 – installation manual – Revision 11 – November 2006
________________________________
________________________________________________________________
__________________________________________________________
____________________________________________________
__________________________
8-4
To enter the serial number of the new lamp, proceed as follows:
Use the cursor key to highlight Reset runtime.
Press Enter to select.
The following dialog is displayed:
Figure 8-4
dialog to enter the serial number of a new lamp
Use the cursor keys to highlight the input field.
Use the numeric keys on the RCU to enter the serial number of the new lamp.
Click Accept to activate the serial number.
These steps have to be performed for both lamps. Then Lamp Optimization should be done.
8.4.2 Lamp Optimization
Since the light is coupled into the light rod by means of a mirror, the position of the mirror together with the
actual lamp properties determine the light yield.
During the Lamp Optimization procedure, the light output of the active lamp in dependence of the tilting angle
of the mirror is measured, and the optimized mirror position for the lamp is determined.
sensitivity of tilt mirror adjustment
0
0.2
0.4
0.6
0.8
1
1.2
00.511.522.533.54
angle [ deg ]
intensity [ a.u. ]
Figure 8-5
influence of tilt mirror adjustment on light intensity
The procedure should be performed subsequently for both lamps. The optimized positions are stored
independently for both lamps, so that after setting the lamp lift in motion and thus changing the active lamp,
the mirror position is adjusted accordingly.