Installation manual

6. Installation of Projection System
OverView D 50" – DOC-3303-5 – installation manual – Revision 11 – November 2006
________________________________
________________________________________________________________
__________________________________________________________
____________________________________________________
__________________________
6-4
• Close the lamp door
• Use the hexagon key and lock the lamp door by turning the screw a quarter turn clockwise.
After the replacement of a lamp module, the new serial number has to be entered, and it is
highly recommended to select the lamp optimization procedure, cf. Error! Reference source not
Error! Reference source not Error! Reference source not
Error! Reference source not
found.
found.found.
found., Error! Reference source not found.
Error! Reference source not found.Error! Reference source not found.
Error! Reference source not found..
In emergency cases the lamp optimization procedure can be skipped for the moment and
carried out later.
6.8 Selecting the correct lamp driver
There are four kinds of lamp drivers for the illumination unit of OverView D. it is mandatory that you check if the
default lamp driver is the correct one for your system!
SXGA+ systems only run with Power Pack lamp driver!
Please refer to Lamp Driver to learn how to set the correct lamp driver!