Installation manual

6. Installation of Projection System
OverView D 50" – DOC-3303-5 – installation manual – Revision 11 – November 2006
________________________________
________________________________________________________________
__________________________________________________________
____________________________________________________
__________________________
6-3
• Close the lamp door
• Use the screw driver and lock the lamp door by turning the screw a quarter turn clockwise.
The Serial Number of the lamps have to be entered, cf. Reset Runtime. In addition, Lamp
Optimization has to be performed once for both lamps, cf. Lamp Optimization. It is
recommended to do these step as soon as possible.
6.7 Inserting the Lamp Modules (Illumination unit with lamps of 200W)
• Fetch the lamp module on its housing. The power socket is on the right side.
• Insert the lamp carefully. Take care that the "tubes" slide on the guide rods.
• When the lamp is removed, you see the two guiding rods on the upper right/lower left and the additional
fan for cooling.
• Press the lamp module tightly into its socket.
• Lock the lamp into its position by pressing the locking slider to the left.
Figure 6-16
inserting the lamp and locking it