Installation manual

6. Installation of Projection System
OverView D 50" – DOC-3303-5 – installation manual – Revision 11 – November 2006
________________________________
________________________________________________________________
__________________________________________________________
____________________________________________________
__________________________
6-2
6.6 Inserting the Lamp Modules (Illumination unit with lamps of 100W/120W)
• Fetch the lamp module on its housing. The power socket is on the right side.
• Insert the lamp carefully. Take care that the "tubes" slide on the guide rods [2].
Figure 6-12
lamp and lamp housing
• Mind the position of the fingers: the force is to apply on the outer part of the module
Figure 6-13
applying the force on the lamp module
• Press the lamp module tightly into its socket
• Apply the securing ring on the lamp and press it in axial direction while turning
Figure 6-14
inserting the securing ring
• Turn the securing ring until its hooks click round the guide rods.
Figure 6-15
inserting the securing ring