Installation manual

6. Installation of Projection System
OverView D 50" – DOC-3303-5 – installation manual – Revision 11 – November 2006
________________________________
________________________________________________________________
_________________________________________________________
__________________________________________________
_________________________
6-13
6.4.2 Cabling of the Multi Input Module and installation of the unit
The power cable of the illumination unit has to be unplugged and lenghtened by the extension cord. The second
interface of the extension cord has to be connected to the power in socket of the Multi Input Module.
The power out socket of the Multi Input Module has to be connected to the illumination unit.
The sensor cable has to be plugged in, as well as the remote control cables and the data cable (DVI) to the
projection unit.
Make sure to guide all cables inside the dark box!
Now you can insert the Multi Input Module into the dark box. Tilt it to enable the insertion and put it up only
when inside the dark box.
Hook the two rods on the bottom of the Multi Input Module into the spares 1-1' of the support.
Tighten the curled screw on the bottom of the Multi Input Module. That's it. No additional fixation is required.
Now the cabling of the sources (front interfaces can be done. When all cables are connected, carefully guide
them through the dark box. Make sure that they are not within the range of projection – otherwise you will see
the cables on the screen!
When all cables are attached, switch on the Multi Input Unit and test it. Subsequently re-attach the top rear cover
of the OverView projection system.