Installation manual

6. Installation of Projection System
OverView D 50" – DOC-3303-5 – installation manual – Revision 11 – November 2006
________________________________
________________________________________________________________
_________________________________________________________
__________________________________________________
_________________________
6-12
6.4.1 Installing the sensor of the Multi Input Module
The IR sensor of the Multi Input Module will be placed upon the IR sensor of the projection unit. Therefore it
comes with two fixation facilities.
Before installing the sensor, plug in the cable! Mind the correct orientation! For better recognition, the socket
NOT to be connected to the sensor (but to the Multi Input Module) is painted black:
One by one, replace the fixation screws of the IR sensor of the projection unit by the fixation facilities of the
sensor of the Multi Input Module. In the picture, you can see the required steps: replace one screw, then the
other, finally attach the second sensor on top of the IR sensor of the projection unit. Make sure not to block the
sensor of the projection unit by a wrong attachment of the IR sensor of the Multi Input Module!
Since the back side of the unit is no longer accessible when the unit is installed, the power cables to and the
sensor cable have to be connected to the Multi Input Module BEFORE inserting the unit into the darkbox.