Installation manual

6. Installation of Projection System
OverView D 50" – DOC-3303-5 – installation manual – Revision 11 – November 2006
________________________________
________________________________________________________________
_________________________________________________________
__________________________________________________
_________________________
6-11
6.4 Installation of the Multi Input Module (SXGA emulation)
On the left side of the darkbox you see the enforcement metal. The support for the Multi Input Module will be
fixed to this enforcement. Unscrew the screw shown in the picture.
Into the vertical profile, a movable nut has to be inserted.
Look at the support of the Multi Input Module. It has a "nose" which will have to be fit into the hole of the
enforcement metal indicated by the arrow. In addition, it has 4 spares, labeled 1-1', 2-2'. For internal installation
of the Multi Input Module, the unit will be hooked into the spares 1-1'. The lateral front edge of the Multi Input
Unit will fit into the slot of the support.
Insert the support. Fit the nose into the enforcement metal. The support of the Multi Input Module will be fixed
on the bottom by means of the screw you previously loosend, and on the top by an additional screw which will
be tightened using the nut inserted into the profile.
After the support has been attached, the IR sensor for operating the Multi Input Module via IR remote control has
to be installed.