Installation manual

5. Wall fixation
OverView D 50" – DOC-3303-5 – installation manual – Revision 11 – November 2006
________________________________
________________________________________________________________
__________________________________________________________
____________________________________________________
__________________________
5-4
The following pictures show a sketch of the installed wall fixation on the display wall:
Figure 5-6
wall fixation, A-shape
Item no. quantities Description
1 2 Profile (length: project specific)
6 2 Screw M10x110
5 1 Fixation bracket display wall side
2 4 Washer U-6-125
12 4 Screw M6x40
4 1 Distance bushing
7 2 Nut M10
8 2 Washer U-10-125
To install the wall fixation at the display wall, proceed as follows:
• Take the fixation bracket [5] and attach it to the profiles of the dark box (linear setup!!) using the screws
M6x40 [12] and the washers U-6-125 [2] (4 screws). In case of a curved setup, the center of the bracket is
fixed to the polygonal connection bracket with 2 screws.
• Position the profiles [1] and apply the bushings [4] (either on top of the profiles as shown in the drawing, or
beneath the profiles).
• Insert the screws M10 [6].
• Use the washers [8] and nuts [7] to fix it.