Installation manual

5. Wall fixation
OverView D 50" – DOC-3303-5 – installation manual – Revision 11 – November 2006
________________________________
________________________________________________________________
__________________________________________________________
____________________________________________________
__________________________
5-3
A-shape version
The length of the profile is project specific and defined by the distance between the rear
side of the display wall and the wall of the building!
The attachment of the profile on the wall of the building allows to be positioned between
30degrees and 60degrees off the straight connection thus also eliminating unevenness of
the wall.
An assembled A-shape version looks like this:
Figure 5-5
photo of wall fixation, A-shape version
First install the bracket to the dark box, then the legs, subsequently apply the short horizontal profile, then the
brackets to be fixed to the wall of the building.
In case of a curved setup, the A-shape version is fixed via the center screws (2 screws
only), fixed to the polygonal connection bracket, whereas for a linear setup the left and
the right screws are used (4 screws), fixed to the profiles.