Installation manual

3. Installation of Screen Module
OverView D 50" – DOC-3303-5 – installation manual – Revision 11 – November 2006
________________________________
________________________________________________________________
__________________________________________________________
____________________________________________________
__________________________
3-9
Step3
When all screws have been applied and fixed,
place the screen module on the guide pins on
the front of the dark box. Be careful to ensure
that the edges of the screens are not damaged.
Screw on the screen module with an hexagon
key size 5 mm (torque 1-2 NM).
The picture on the right shows tightening one
of the screws at the bottom.
Try to fix the screen centered to the darkbox
(visual check)
Tighten all 4 screws!
Completely remove the two horizontal
movement screws.
Step4
The static screen itself and also the projection
module equipped with the static screen has to
be labeled! Wrt screen, put the label between
the two facilites to block horizontal mevement.
For the label and the position of the label on
the profile see picture on the right!
It is mandatory to stick to the rule mentioned
above and also to put on the label.
In case the screens have to be removed (either
the display wall has to be de-installed, or
either a screen has to be replaced) there is a
high risk of crashing all screens if the static
screen is not known!
Mark the static screen!
The static screen defines the movability of all screens in a display wall.
Dismounting a screen requires the knowledge of it's movability, cf. De-mounting the
seamless screens