Installation manual

3. Installation of Screen Module
OverView D 50" – DOC-3303-5 – installation manual – Revision 11 – November 2006
________________________________
________________________________________________________________
__________________________________________________________
____________________________________________________
__________________________
3-2
3.1 Installation of the standard screen module for systems with SXGA emulation
In case of an SXGA system with an SXGA+ projection unit and a Multi Input Module, a spacer has to be mounted
between the darkbox and the screen to enhance the depth.
The spacer comprises 2 horizontal and two vertical profiles which have to be assembled. This frame then is hung
on the pins of the darkbox.
Subsequently the screen module is hung on the guide pins, and then the spacer frame together with the screen
is fixed by 4 M8x45 bolts.
Do not insert the bolts in the spacer frame! The picture below only demonstrates where
the bolts will fix the spacer frame. Actually the bolts are inserted from inside the darkbox
and fix the spacer frame and the screen module!
• Assemble the spacer frame (no bolts!) and hang it on the 4 guide pins on the front of the dark box.
• Place also the screen module on the guide pins (Figure 3-3) on the front of the dark box. Be careful to
ensure that the edges of the screens are not damaged.
Figure 3-2
Screen module
• Screw on the screen module with an hexagon key size 5 mm (torque 1
(torque 1(torque 1
(torque 1-
--
-2 NM).
2 NM).2 NM).
2 NM).